Issues with Extruder Stepper Motor After Motor Driver Upgrade | 3D Printing | Page 1

elder gazelleBOT Sep 30, 2023, 5:07 PM

#

AI Help

That's great to hear! Tweaking and fine-tuning can make a significant difference in the quality and performance of your 3D prints. If you have any specific questions or need help with troubleshooting, feel free to ask!

icy berry Sep 30, 2023, 5:08 PM

#

Issues with Extruder Stepper Motor After Motor Driver Upgrade

icy berry Sep 30, 2023, 5:29 PM

#

I recently upgraded my Anycubic Mega X from hr4988 drivers to tmc2225 drivers. I only replaced the xyz motors and it worked out well with mostly just plug-and-play and only minor firmware updates. However when I changed out the driver for my extruder the motor wouldn't rotate and creates a loud buzzing sound even without load. I suspect it is because the extruder motor is the only 6pin stepper motor on the printer with the xyz motors being 4pin. Not sure what steps I need to take and any help would be greatly appreciated.

#Issues with Extruder Stepper Motor After Motor Driver Upgrade