#ender 5 plus skipping

1 messages · Page 1 of 1 (latest)

nocturne sluiceBOT
#
AI Help

It sounds like you are experiencing layer skipping during your 3D print. Layer skipping can occur due to various reasons, including mechanical issues, software settings, or filament-related problems. Here are a few troubleshooting steps you can try:

  1. Check your filament: Ensure that your filament is not tangled or causing any restrictions in the filament path. Try a different spool of filament to see if the problem persists.

  2. Examine the extruder: Inspect the extruder assembly, making sure there are no clogs or obstructions in the hotend or nozzle. Clean the nozzle if necessary.

  3. Verify slicer settings: Double-check your Cura slicer settings, particularly layer height, print speed, and temperature. Ensure that these settings are suitable for your printer and filament.

  4. Check belt tension and movement: Make sure that the printer's belts are properly tensioned and are moving smoothly. Loose or overtightened belts can cause skipping issues.

  5. Monitor temperature: Monitor ...

WARNING: This response is AI generated and may contain errors.