SKR 1.4 steppers not moving

[fleet path]

AI Help

Based on the information provided, it's possible that you may have misconfigured your printer.cfg file. Double-check the configuration settings for your stepper drivers and make sure they are correctly assigned to the correct axes.

Ensure that the stepper_driver field in the [stepper_a] (and other stepper sections if applicable) is set to a4988. Verify that the step_pin, dir_pin, and enable_pin fields are properly defined for each axis.

Also, check if the stepper motor cables are connected correctly to the stepper drivers on your SKR 1.4 Turbo board.

If you're still experiencing issues after verifying these settings, it's recommended to seek further assistance from the Klipper community or the manufacturer of your SKR 1.4 Turbo board.

WARNING: This response is AI generated and may contain errors.

[buoyant carbon]

are they making a grinding sound?

interesting I would check the motor wiring

[fleet path]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[fleet path]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[modest python]

Has the current been set on the drivers correctly?

[fleet path]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.