#BigTreeTech UBL->level corner not working

1 messages · Page 1 of 1 (latest)

placid sandBOT
#
AI Help

It seems like there may be a configuration issue with your Marlin firmware or a bug in the firmware itself. Here are a few troubleshooting steps that you can try:

  1. Double-check your Marlin configuration files to ensure that the level corners feature is enabled. Look for the following line in your Configuration.h file: #define ENABLE_LEVEL_CORNERS.
  2. If the option is already enabled, try recompiling and uploading the firmware again to see if that resolves the issue.
  3. If the problem persists, consider rolling back to the previous version of Marlin that was known to work correctly with the level corners feature. This could help determine whether the issue is related to the Marlin upgrade.
  4. If none of the above steps work, you can try reaching out to the Marlin community or the firmware's development team for further assistance. They may be able to provide additional insights or solutions to the problem.

Remember to always back up your firmware and configuration files before ...

WARNING: This response is AI generated and may contain errors.
slender mango
#

And the AI help is of no use, that is the marlin mode l corner leveling, not the TFT own way. I do not have the exp1 and 2 cables on my setup, so can not use marlin mode.

#

Printer is a modified Ender 5 Plus, BTT SKR2 board, TFT70 display.

#

Marlin of night build of yesterday, TFT firmware as of today master branch

placid sandBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.