#Advice to reduce/eliminate stringing on a new Sovol SV06?

1 messages · Page 1 of 1 (latest)

west flareBOT
#
AI Help

To reduce or eliminate stringing on your Sovol SV06, there are a few things you can try:

  1. Adjust the retraction settings: Start by increasing the retraction distance gradually. Try increasing it to 1mm and check the results. You can also increase the retraction speed to help reduce stringing.

  2. Temperature adjustments: Stringing can occur if the temperature is too high. Consider slightly lowering the printing temperature in increments of 5 degrees Celsius and observe the results. eSUN PLA+ recommends a temperature range of 190-210°C, so you can try printing at 190 or 185°C.

  3. Enable or increase the minimum travel distance for retraction: Some printers have this option in their firmware or slicer settings. Increasing the minimum travel distance will ensure that retractions only occur when necessary, reducing the chance of stringing.

  4. Check for filament quality: Sometimes, poor quality or old filament can contribute to stringing. If you have another filament available, try p...

WARNING: This response is AI generated and may contain errors.
west flareBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

warm rover
#

What slicer are you using?

west flareBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

bright ridge
#

?solved