AI Help
Based on your description, it sounds like you may be experiencing some under-extrusion that could be causing the "slow down" effect you're seeing in your print. Under-extrusion happens when the printer isn't able to push out enough plastic, leading to gaps in the finished print, similar to what you're seeing.
Here are some things you could try to troubleshoot and address the issue:
-
Check your extruder and hot end for any clogs or obstructions that could be blocking the flow of plastic. Clean any debris that you may find.
-
Make sure that your filament is properly loaded and fed into the printer and that it is not slipping on the extruder gear.
-
Check your printer's firmware settings to make sure that the extruder steps/mm are properly calibrated.
-
Adjust the temperature of your nozzle. If the nozzle is too hot, the filament could become too liquid and cause issues with the extrusion.
-
Try increasing the flow rate of your filament in the slicer settings, this may help...
vivid wing
flint mist
junior swallow
