SV06 | is there something you can print to move this fan so it doesn't draw air from the heated bed? | 3D Printing | Page 1

raw crescentBOT May 31, 2023, 7:38 PM

#

AI Help

Moving the fan to draw less hot air from the heated bed may not solve the problem, as the purpose of the fan is to cool the extruded filament. However, if you still want to relocate the fan, you should be able to do so by extending the fan cable and mounting the fan in a different location. You may need to print a custom fan duct to ensure it is still blowing on the extruded filament. Keep in mind that modifying the printer's original design may affect its performance, and you should proceed with caution.

raw crescentBOT May 31, 2023, 8:43 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

raw crescentBOT May 31, 2023, 9:47 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

raw crescentBOT May 31, 2023, 10:52 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

dawn cradle Jun 1, 2023, 12:26 AM

#

maybe this?

https://www.thingiverse.com/thing:5888645

Sovol SV06 Fan MOD by RIKDESIGN

I made this fan mod to assist the original Fan on the Sovol SV06. The fan mod does not change the original printhead/extruder. Easy assembly and big results. The Fan is connected to the FAN2 header on the mainboard, make a splitter. Only 58 gram
Parts:
5015 24Volt Fan
2x M3x20
1x M3x8
2pin_XH_2.54 cables (Male and Female) to make mainboard spli...

#

@exotic shore

#SV06 | is there something you can print to move this fan so it doesn't draw air from the heated bed?