#First Layer issues

1 messages · Page 1 of 1 (latest)

raw cobaltBOT
#
AI Help

Congratulations on achieving a good test print! A couple of things could be causing the issue you mentioned:

  1. Flow rate: As you mentioned, you may be having flow issues. You can adjust the flow rate in your slicing software or directly from the printer menu. Try increasing or decreasing the flow rate by small increments and see if that helps.

  2. Bed leveling: It sounds like you've already checked the bed leveling with a height map, but another possible issue could be the first layer height. Make sure the first layer is being squished enough onto the bed. Try adjusting the Z-axis offset to make sure the nozzle is at the correct distance from the bed during the first layer.

Additionally, make sure your nozzle and bed are clean, and that your filament is not tangled or experiencing any other issues. I hope these suggestions help!

WARNING: This response is AI generated and may contain errors.