Infill only larger parts PrusaSlicer

[kind monolith]

AI Help

Yes, there are a few ways to achieve this. One option is to adjust the infill settings in your slicer software so that a lower infill density is used for areas of the model that are smaller than a certain size. For example, you could set the infill density to 20% for areas larger than 20mm, but reduce it to 5% for areas smaller than 10mm.

Another option is to use a feature called "infill density modifiers" in some slicer software, which allows you to manually adjust the infill density for specific areas of the model. You could use this to decrease the infill density or eliminate it altogether for small sections of the model.

Note that reducing or eliminating infill in some areas may affect the overall strength and stability of the final print, so make sure to test your settings and adjust as necessary before printing your final model.

WARNING: This response is AI generated and may contain errors.

[grand osprey]

Can I change the perimeter only for smaler sections? I have a higher speed for infill and I could lower it is only a problem for the small parts here

[alpine quail]

If you split the model into two models you can change the settings per model.