Spacer print test | 3D Printing | Page 1

brave knotBOT May 16, 2023, 11:25 AM

#

AI Help

There are a few things you can try to improve your print:

Increase the bed temperature to around 110-115°C to improve adhesion.
Enable the part cooling fan at around 50% to reduce the chances of warping.
Increase the nozzle temperature to around 250°C to get better flow and adhesion between the layers.
Try retraction distance of around 2-3 mm instead of 6.5mm, this will help reduce stringing.

Remember, the optimal settings will depend on the specific 3D printer, filament, and model you are printing. Therefore, it is important to experiment with different settings to find the optimal configuration for your specific situation.

plush saddle May 16, 2023, 11:30 AM

#

increasing temp on the bed may not be the right option

#

I'd try reducing it if necessary actually. I agree to try and reduce retraction.
Please specify which printer this is

brave knotBOT May 16, 2023, 1:02 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

brave knotBOT May 16, 2023, 5:52 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

brave knotBOT May 18, 2023, 2:12 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

#Spacer print test