#new Creality Ender 3 ESUN ABS+

1 messages · Page 1 of 1 (latest)

placid fernBOT
#
AI Help

Yes, you can use the Capricorn tubing with your Ender 3's stock hotend and upgrade to a direct drive kit from your Geeetech A10. A direct drive setup can help improve print quality, especially when using flexible filaments. However, do keep in mind that ABS+ can be a challenging material to print, so it may take some experimentation to get the right settings dialed in. Good luck, and happy printing!

WARNING: This response is AI generated and may contain errors.
tawdry jacinth
#

yet again no, capricorn is just PTFE and will start putting off fumes at 230 and melt at ABS temps. you need an all metal hotend to do ABS

placid fernBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.