#print came off build plate and stuck to the hotend

1 messages · Page 1 of 1 (latest)

thin violetBOT
#
AI Help

If you have plastic filament stuck on your hotend, you can try the following steps:

  1. Turn off the hotend and let it cool down to room temperature.
  2. Remove the nozzle and clean any visible plastic using a nozzle cleaning tool.
  3. Heat the hotend to the temperature of the filament you were printing with.
  4. Gently push a filament through the hotend to help push out any remaining clogs.
  5. Use a small brush or needle to clean the hotend bore and remove any remaining plastic.
  6. Replace the nozzle.

If you have plastic stuck on your heater block or other parts of your 3D printer, you can try scraping it off using a flat tool or scraper. Be careful not to damage any important components. You can also use a little bit of rubbing alcohol to clean the heater block.

WARNING: This response is AI generated and may contain errors.
pliant depot
#

youre gonnna need to heat it up to below printing temp and slowly try to peel it off

#

yeah it might take some time though

#

becareful around the wires and dont let it burn to much

#

Thats what she said

#

Sorry

#

Make sure that its not the hot end leaking i guess

#

After u figure this cleanup out anyways

#

Might be under tightened though?

#

What printer is this on?

#

hopfully sourcing another hot end incase it breaks isnt too hard

#

Yeah and hopefully no broken therm, those wires arent very strong usually haha