need help with print settings for .6mm nozzle | 3D Printing | Page 1

solid patioBOT Apr 12, 2023, 10:48 PM

#

AI Help

Overhangs can be improved by printing with a slower print speed and lower temperature, as well as adjusting your cooling fan settings. Globs and stringing can be caused by over-extrusion, so you may want to try reducing your flow rate or adjusting your retraction settings (such as increasing the retraction distance or speed). It's also helpful to check if your filament is tangled or if there are any clogs in your nozzle. You can perform a cold pull or heat the nozzle to clear any blockages.

bronze vapor Apr 12, 2023, 10:51 PM

#

need help with print settings for .6mm nozzle

solid patioBOT Apr 12, 2023, 11:52 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

pine spire Apr 13, 2023, 5:29 AM

#

Temp is too high for pla so you are probably overextruding. Try 200 degrees. You might also want to up the fan speed if it's not maxed out already.

solid patioBOT Apr 13, 2023, 6:32 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

gilded tusk Apr 13, 2023, 1:54 PM

#

you also print 1mm line width with this 0.6 nozzle. While that is possible, its not easy to tune

#

for the thick z seams, you can try coast/wipe in the slicer OR retuning pressure advance for the layer width you are using

#

bridging at that volume of plastic will always be very difficult without extensive tuning of bridging settings

#need help with print settings for .6mm nozzle