azure charm
Just finished re-watching Toy Story 1 & 2 and was inspired to make some little Toy Story aliens 😛
I found the file via Thangs and used the post processing features in Cura to enable a filament change at specific layers, where I then swapped the filament to another colour, purged it a little, and continued printing.
It took a few attempts til I was happy with the colours and result.
The final version of this print took 5 filament changes (not including the initial colour), and a total of about 40 minutes to complete (including changing the filament) on my Monoprice Select Mini v2, using the "Finer" layer height pre-set.
The eyes are just drawn on, somewhat poorly with pen, btw! Haha
soft kiln
earnest flare