✅｜help-forum
Updated Firmware and SD card has bricked
Hardware
Software
Brand new Bambu Lab X1C very often can't extrude.
Hardware
Help fine tunning impression
Other
Help designing speaker mounts
Modelling / CAD
Filament stuck in extruder
Hardware
Other
Installed sv06+ hot end in a sv06 extruder - can't level
Hardware
Other
Software
Anyone know what causes this bubbling on large flat surfaces?
Other
I NEED HELP (its not that urgent)
Electronics
Stringing issues 🥺🥺
Hardware
Modelling / CAD
Other
Buck converter getting really hot
Electronics
Elegoo Neptune 4
Hardware
Software
improve 1mm nozzle prints
Other
Benchy test did not go well
Hardware
Bed Adhesion Problems with Ender 3 V3 SE
Hardware
Software
.2nozzle troubleshooting bambu lab a1
Hardware
Software
Slicer removes hole in my bird house
Modelling / CAD
Other
Software
So much squeaking
Hardware
Adding a relay module to a GPIO pin. relay cannot deactivate.
Hardware
Electronics
Software
CR-10 doesn't know how to home
Hardware
surface finish on SV06 ACE
Hardware
Other
Software
Wobbly Extruder Bar
Hardware
Any guesses what happened here?
Hardware
Saturn 4 Ultra resin exposure
Hardware
Electronics
Any way to fill the small holes during the slice?
Software
Any way to force the Centauri Carbon to heat the chamber before printing inside of Orca Slicer?
Hardware
Software
Ender3 V2 issues with Sprite mod, HELP PLEASE!!!
Hardware
weird problem
Hardware
Other
Software
Help Supports Orca
Software
Idk whats going on
Hardware
Vase 4mm into print changes shape
Hardware
Other
Software
wavy walls and z wobble (i have tried everything to fix it pls help me)
Hardware
Software
Too low of temp or Nozzle too close?
Other
pi crashes on start up when printer is connected and on, and pi sometimes crashes at save_config
Hardware
Software
Electronics
Puffy filament, jagged imperfections.
Hardware
Beginner - Copymaster3D 300
Software
Extruder motor not working help!
Hardware
Electronics
My z axis stepper motors are getting hot, is that normal?
Hardware
1/64 wheels
Modelling / CAD
Software
Bambulab X1C mesh bed leveling seemingly not working
Hardware
Help with under extrusion on benchy hole
Software
How should I slice this?
Software
Bambu Studio Issue
Software
SV06 ramming into left side
Hardware
Buck converter: fan wont start
Electronics
Filament stuck in extruder
Hardware
Need new one
Electronics
Possible reasons as to why the capacitor blew
Electronics
Mainsail refusing to connect
Software
Random klipper disconnects
Hardware
Software
Electronics
Weird Bltouch probe behaviour (failed to home) (Artillery Hornet)
Hardware