✅｜help-forum
How do i fix this
Other
need help
Hardware
Filament gets stuck in extruder
Hardware
filament isn’t going through the extruder??
Hardware
Overhangs Above Supports/Nozzle Rubbing on Print
Other
Neptune 4 Pro making high pitched sounds
Hardware
New Filament doesnt work
Other
lithopane light streaks
Hardware
Other
print quality
Software
Alr guys, why did this happen
Other
can't get accurate prints on kobra 2 neo
Hardware
Filament not extruding mid-print
Hardware
Nozzle picks up Filament and drops burnt "tears"
Hardware
P1P Constantly failing
Hardware
SV06+: filament not reaching bed and doing poor extrusion
Hardware
x1c making grinding noises.
Hardware
no successful prints at all
Hardware
Filament not coming out
Hardware
buying new ender 3 v2 display main board
Hardware
Electronics
Why my Ender 3 S1 won't print this...
Hardware
Help With Leveling Elegoo Neptune 4 Max Bed
Hardware
Software
Electronics
New to 3d printing, any help or advice is welcome
Modelling / CAD
Benchy ajustments
Software
Dotted lines
Hardware
Sidewinder x1 - Added Magnetic plate, now extruder assembly is homing too low
Hardware
Creality Ender 5 S1 and Power Outage
Hardware
Other
Electronics
RRF Manual Input Shaping
Software
I am new to 3d printing and have no clue what I'm doing, but what type of supports should I use.
Modelling / CAD
Software
Ender 3 Pro with Klipper - underextrusion at start of lines
Hardware
Software
CR10 - Issues printing a large base
Hardware
Stringing across area where the printhead never moves over
Hardware
help with multi color print ender 3
Other
Software
Did this happen bc the calibration was wrong?
Other
Hey guys, i have recently bought an BIQU-B1 but i have a problem.
Software
SV06+ not putting out filament anymore
Hardware
Software
Custom 3D printer
Hardware
Other
Electronics
SV06 Bed Leveling Crashed Extruder Into Bed, Now What?
Hardware
Single extruder filament change issue
Software
clog?
Hardware
Large, long print piece slightly bent upward on the ends of the bottom surface - why?
Hardware
Other
ender 3 print not working at all
Hardware
Software
Unusual clicking/skipping noise
Hardware
randomly clogging
Hardware
Termistor wire cut, hotend full of plastic
Hardware
hi guys ive lost the needle to unclog my printer does anyone know what else i could use? i have an a
Hardware
Increase stiffness of Polypropylene Filament
Other
Black screen issue
Hardware
can I get these small dents out I can’t print with them
Hardware
my bl touch isn't working
Hardware
Software
Electronics
Bad prints after replacing nozzle.
Hardware