✅｜help-forum
ender 3 v2 printer started up and I got stuck
Hardware
Software
Sovol Sv06 plus not turning on
Hardware
Electronics
3d printer being weird
Hardware
Software
Electronics
Ender 3 v2 Sprite Pro, CR Touch Firmware
Software
Reliable 3d Printing Service
Other
I'm lost plz help, can't get prints to stuck
Hardware
Software
X Driver Suddenly Died?
Hardware
Software
Unrealistic amount of filament changes
Software
Ultimaker Cura/Prusa fail to print larger models
Software
My printer prints badly but it is calibrated well
Hardware
Electronics
probe deploys, doesn't stop z
Software
Need help finding a replacement belt
Hardware
p1p weird curved artifacts across layers
Hardware
As beginner what software should i use
Modelling / CAD
Software
Flash firmware?
Software
Ender S1 Pro Current Issues
Hardware
Electronics
Software
incomplate prints #help
Hardware
Modelling / CAD
Anyone know why my brims look like this?
Hardware
Strange clicking noise. Nozzle brushing past an interior/infill support maybe?
Hardware
SV06+ Faster
Software
Electronics
wavy layer lines on supports?
Other
First layer issues CR-10 SE
Hardware
Software
Terrible Bed Adhesion
Hardware
Other
Software
I adjusted the table in the Ender 3 v2 model, but when starting the process, the printer starts from
Hardware
Printing shapes in transparent PETG
Hardware
Other
Software
Firmware changes on Ender 3 V2 Neo
Software
Mystery periodic layer defect
Hardware
Other
My printer is busted, the z offset is busted and it makes this sound when I start the print
Hardware
BMG Under Extrusion
Hardware
Other
Software
Can the Ender 3 V2 Heated Bed Be Used with 12V circuitry?
Hardware
Electronics
How to clear a block in the heat sink (?) part, just above the nozzle
Hardware
Printer stops extruding after first or maybe second layer when printing big surfaces
Hardware
Very mysterious PETG blobbage
Hardware
INVERT_Z_DIR Not Working Marlin V 2.1.2.2
Software
Bltouch wire length limit?
Hardware
help with improving my prints, im new :)
Other
Software
Z motor only goes up instead of going down after auto home
Software
Electronics
bed wont stay/ get level
Hardware
When trying to level my printer, it makes a weird sound and vibrates
Hardware
Electronics
Software
Lower-level Sagging
Hardware
Is it something doable?
Hardware
Other
Help with firmware
Software
help with first layer
Software
Origin of defects
Other
Problem with first layer
Hardware
Software
Strange web and poor adhesion
Hardware
Need help to split 3dprint in two halves!
Other
klipper orca input shaping?
Software
solved
Hardware
First layer upwards warp
Hardware