✅｜help-forum
printer stops moving on z halfway
Hardware
car spoiler
Modelling / CAD
Other
Best current Air Filter for Enclosure?
Hardware
Electronics
TPU bed adhesion issues
Hardware
Two calibration cube issues: Strange horizontal lines and Letters off-center.
Hardware
Blender 3D Toolbox issues
Modelling / CAD
Strange overextrusion on overhangs with 0.6 nozzle.
Software
Klipper bed mesh is weird!
Hardware
Software
my ender 3 v2 is stuck on the start screen
Software
Error compiling Marlin for Flsun Q5
Software
Weird texture on the first layer
Hardware
Software
Cant connect to moonraker
Hardware
OrcaSlicer support help
Hardware
Prusa Slicer significantly slower than Cura with Snapmaker A250 Dual Extruder
Software
no trigger on probe after full movement
Hardware
Other
Software
warping and infill outside print
Hardware
very random under extrusion
Hardware
Other
Neptune 4 printer leveling error
Hardware
anycubic kobra 2 neo upgrade
Hardware
omg
Hardware
trouble with PLA not sticking to bed properly
Hardware
Stringing just became a hell and it won't stop
Hardware
missing layer mystery
Hardware
The nozzle just keeps knocking the other layers (in the first layer)
Other
Top layer
Other
3d Printer has zeroed its z axes to the middle of total height
Hardware
no printer attached error after hard reset
Software
For fun, investigation into counterweighted axis.
Hardware
Help fix benchy's hull?
Other
ender 3 issue?
Hardware
filament not feeding k1 max
Hardware
psu buzzing
Hardware
Sensorless probing, while keeping physical Z_MAX endstop in klipper.
Software
Thermal runaway error weeks after hot end upgrade
Hardware
Electronics
Extruding too much and fraying
Hardware
Other
Software
Printer only Printed the Supports?
Modelling / CAD
Software
My nozzle is covered in burnt plastic.
Hardware
PrusaSlicer first layer temp incorrect
Software
what does this mean
Hardware
Other
first layer issues, need help troubleshooting
Hardware
Software
Disable Support Bed Adhesion Grid
Software
Help with designing a hinge for a lid :)
Hardware
Modelling / CAD
is this too low to the plate?
Hardware
artifacts on outer wall
Hardware
looking for ptfe tubes
Hardware
not understanding what’s the orange part
Software
MCU will not communicate with printer on new main board install and flash.
Software
Can't connect to BTT Pi after flash
Software
Cura measurement tool not working
Software
weird spots on prints | creality k1
Hardware