✅｜help-forum
sovol 06 + klipper non stop loading
Hardware
Software
werid spaces on prints
Other
Ender 3 V3 SE - Diagnostics
Hardware
Software
Z seam issue or?
Software
cr6se failing to heat
Other
Electronics
it was working and then this error came out and won't let me preheat or print.
Hardware
Other
Software
Electronics
Share your klipper/fluidd/cura timelapse setup?
Software
LDO Super Power vs Super Speedy
Hardware
Electronics
help
Other
Pneumatic connection stopped working
Hardware
Electronics
Best accessories for 3D printers
Other
Filament snapped?
Hardware
z axis cannot go up
Other
Fail help
Hardware
Usb problem
Software
bricked ender 5 plus
Hardware
Software
Printer trying to print off bed
Other
Software
Elegoo Neptune 3 max layer lines
Hardware
Other
Prime Corner Lifting
Other
Technical Interview Questions
Hardware
Other
prints are spongy and fall apart
Electronics
heres a fun First Layer for you after i mounted and used my beacon to calibrate
Hardware
Electronics
Software
target temp software issue (slicer related?)
Software
Replacing makerbot internals/software with raspberry pi
Hardware
Software
need advice for which camera to use
Hardware
4 different printers each with their own problems please help
Hardware
Software
Electronics
First few layers not printing right with the same settings it used to print fine on
Hardware
Other
Electronics
Flow
Software
Stray voltage of P1S
Hardware
Electronics
Filament blob sticking to nozzle
Hardware
Software
Warped Layer Lines
Hardware
Other
Modelling / CAD
Electronics
Software
Figuring out in-model supports and best orientation for a part - keeps failing on me.
Other
nozzle dragging
Hardware
Software
Ender 3 blower dont blow
Hardware
Electronics
octoprint remote firmware flash python not installed
Software
Adhesion problems
Hardware
Software
Model complete but not after prepare it
Software
Is there ANYONE in Ireland or UK that Could Help Me, I am Desperate for Help
Other
I think I have Z Banding and would like some help for my current setup
Other
Blender Help
Modelling / CAD
Software
Problem is back. Please help, absolutely no idea what to do
Hardware
Uneven Printing on Anycubic Kobra Max 2 - Need Help Troubleshooting
Hardware
Other
Electronics
someone help, Ender 3, I print this twice and it came out same result.
Other
Bambu a1 mini
Other
orcaslicer crash wipe
Software
Neptune 3 Max powering down at 2mm tall
Hardware
Bambu lab p1s/bambu lab pla, is this over-extrusion? Are my temps too hot?
Software
A lot of problems
Software
At a sudden dead end again. Z-Offset issues? Printings not sticking and too high all the sudden...
Software
Setting Bambu Studio for PETG
Software