Just recieved my 60 HE v2 and I ordered the GEON Raw switches. The guide for installation showed the method for installing the Lekker switches which had the LED at the top and the logo at the bottom. These GEON switches prefer to be the other way around, therefore the RGB doesn't look as shown in the pictures on the website. Is this just a limitation of the switches or should I have forced the GEON switches the other way around? It could even be the keycaps I got sent?
#RGB with GEON Raw HE switches
lost lance
ruby talonBOT
Just recieved my 60 HE v2 and I ordered the GEON Raw switches. The guide for ins...
Thanks for posting your support request!
Note: #community_support is only for answering general questions and for troubleshooting.
All order-specific and shipment-specific support must be handled via the Wooting Support Wizard*
(You need to create an account on the Wooting Hub, using the same email address as your purchase. The account is not created for you automatically!)
Troubleshooting your Wooting Keyboard? Try these steps first!
Basic Troubleshooting
Questions about shipping, or what to do if your shipment has a problem?
Possible Problems During Shipping (with Solutions)
Looking for information about your specific order?
You can find that on the Wooting Hub! There you can also add upgrades, update your shipping address, and much more.
Is your order about to ship and you need to pause it for any reason?
Place it on hold via the Wooting Hub!
Do you need to...
- Cancel an order?
- Return/Refund an order?
- Get assistance with placing an order?
- Change the items in your order?
- Change your shipping address to a different country?
- Return a recent purchase?
- Get warranty support?
All of these types of requests need to be made via the Wooting Support Wizard!
lost lance
The force to install the switch one way instead of the other was very different, felt as though it wasn't meant to go in.
marsh falcon
can you show and image of which way around you say it takes more force?
lost lance
can you show and image of which way around you say it takes more force?
Thanks, see attached.
harsh smelt
Left is how I installed. The right is what required more force.
right one is correct -> LED window for RGB should be UP/North
lost lance
Thanks. That's crazy, it felt like they wouldn't go in. I'll strip a coouple out and check back.
marsh falcon
hm wonder why it would feel that way tbh
lost lance
I could be being overly cautious. I will try a couple now though.
I think im stuck this way no Im afriad Ive just tried taking one of the switches out and and the plastic covering the LED has snapped off.
marsh falcon
they dont snap off
they are just slide in inserts
unless you mean smth other than the prism above the led area
lost lance
Its a small piece of plastic that looks like it slid out. These switches are cemented in. I don't seem to be able to remove them
I think I'll leave it as is. The amount of force required to take these out is just too much. I feel like I'm going to bend and snap the entire board.
lost lance
they dont snap off
This is right. I've managed to pull a few of them out and replace them but sadly the tool to remove the switches has broken the prongs have just snapped off. I've ordered a set of steel ones from amazon and continue tomorrow. Thanks for your help.