Reconsider adding manual calibration, if you don’t want it to be the only calibration option, at least have it separately. It also wouldn’t need a millimeter view, just % is fine and doesn’t require the user to select their switch for each different switch type they have installed. Switches with weak magnets that are currently not optimally supported would be with manual calibration. O-Rings, Travel Limiters and such would all be supported. Saw the stream today and calibration being talked about again, and the struggles with it. Just think about the benefits, it also takes less than 40 seconds to manually calibrate a whole board. 😌
#Manual Calibration x2
wary hull
wary hull
bump 😔