Most common panel lining chisel sizes? | Gunpla Builder's Association | Page 1

chilly terrace Jan 29, 2026, 7:48 AM

#

Also, side question, are the SAB chisels worth it?

quaint hemlock Jan 29, 2026, 9:23 AM

#

read other posts on same subject.
sab are fine if u have small delicate hands. easy to break otherwise.

chilly terrace Jan 29, 2026, 11:22 AM

#

Just read the other post and I'm leaning towards the Dspiae starter bundle. Do you know anything about that?

quaint hemlock Jan 29, 2026, 11:24 AM

#

i think i was the one to recommend it.

chilly terrace Jan 29, 2026, 10:24 PM

#

Oh maybe lol

#

Any tape recommendations?

paper tinselBOT Jan 29, 2026, 10:26 PM

#

HEY LOOK AT ME @chilly terrace! I JUST MADE YOU level 5 !

quaint hemlock Jan 30, 2026, 2:37 AM

#

dymo lable embossing tape. it has a peel-off backer and is quite thick. makes it easy to cut angles in to it making it easy to lay out precise secondary cuts . has enough stick that u can use a couple times. cut them in halves lengthwise to get even more from it . doesn't do well wrapping around corners.

chilly terrace Jan 30, 2026, 10:38 AM

#

Thank you for all of the info 👍

#Most common panel lining chisel sizes?