Extra Movement & Purge | ArmoredTurtle 3D | Page 1

pseudo jackal Mar 20, 2026, 9:12 PM

#

2 questions.. 1) When it purges clean then kick then clean.. before it moves toward the print.. it extruded extra.. What setting to adjust here? 2) When it homes at the beginning. It poops, clean, Kick, clean then goes to center then goes back to clean (brush)) then Park. What setting to adjust.

celest canyon Mar 20, 2026, 9:35 PM

#

what’s your goal?
sounds like you are doing this directly by macro call?

pine whaleBOT Mar 20, 2026, 9:35 PM

#

Please run this debugging script when not printing and post the resulting link in chat.

Troubleshooting - Armored Turtle Documentation

Armored Turtle Project Documentation

pseudo jackal Mar 20, 2026, 11:15 PM

#

You can see bottom left and top right has goop on the purge tower. I don't care but if this can be fixed that be dope

rn_image_picker_lib_temp_a776fa14-61c2-4765-80e9-63911890eca3.jpg

#

https://termbin.com/34hh

worthy hill Mar 20, 2026, 11:23 PM

#

do you have ramming disabled in your slicer settings?

#

https://www.armoredturtle.xyz/docs/initial-startup/09-slicer-config.html#material-settings

pseudo jackal Mar 20, 2026, 11:44 PM

#

just did

#

i deleted my old profile

#

i didn't realize

#

could that be the issue?

#

I am using SB CW2 with Cutter

#

Filamatrix

#

I read somewhere that post 2.2.0 ramming setup was not needed

#

maybe my error

celest canyon Mar 20, 2026, 11:51 PM

#

It still needs to be disabled by the checkbox

pseudo jackal Mar 21, 2026, 12:15 AM

#

isnt it you put 0?

#

that is already disabled

#Extra Movement & Purge