Hi guys i'm stuck on calibration . After launch AFC_Calibration for example bowden lenght on lane 1 , boxturtle starl to load filament but after a short lenght it stopped .
What can be ?
#Stuck on calibration Voron Trident
crisp heath
tacit solstice
What got printed to the console after it stopped?
crisp heath
Ciao "lane1 failed to calibrate bowden length while moving to toolhead. Failed after 500mm
if filament stopped short of the toolhead sensor/ramming during calibration
use the following command to increase bowden length
SET_BOWDEN_LENGTH HUB=Turtle_1 LENGTH=+(distance the filament was short from the toolhead)"
hoary canyonBOT
Please run this debugging script when not printing and post the resulting link in chat.
crisp heath
tacit solstice
send the following in console then try the calibration again
SET_BOWDEN_LENGTH HUB=Turtle_1 LENGTH=2500
crisp heath
seem to work with lane 1 . I reviewed also some mechanical things . now i try lanes remanent
tacit solstice
you only need to do the bowden length with 1 lane so if that was successful you should be good to go
crisp heath
Hi again , now i'm issue with Boxturtle when rewind filament , lane done work even if i tested it .
warm geyser
I would suggest updating to the newest AFC version that was pushed out and then add hardware_pwm: True to all your AFC_Stepper sections in your AFC_Turtle_1.cfg file. See this announcement #afc-updates message
crisp heath
hi Tommy let me check
Ciao Tommy problably make some mistake :
Monnraker isnt update like your announcements
warm geyser
Scroll down more this was the latest update pushed today, I linked you to the one from Sunday as it has details about the hardware PWM in it
crisp heath
Hi ok i added hardware_pwm: True but not work . I have fear need to disassembly again the respooler.