BT_LANE_MOVE LANE=2 DISTANCE=-50 directions inverted on 3, 4 | ArmoredTurtle 3D | Page 1

kindred tendon May 31, 2025, 5:23 PM

#

Ok, i did a quick test and it seems on lanes 3 and 4, this command FEEDs filament in with -50, but on 1 and 2 it pulls filament out. What the heck did i do wrong? Should i invert pins on 3 and 4? I assume +50 to feed, -50 to pull out.

south hemlock May 31, 2025, 5:28 PM

#

@kindred tendon You can try inverting the dir_pin on those specific lanes in the Turtle_1.cfg

kindred tendon May 31, 2025, 5:34 PM

#

hmm, did that tried calibrate lane 4, got error Lane failed to calibrate retract to extruder after 290.0mm

south hemlock May 31, 2025, 5:37 PM

#

Did it move in the proper direction at least?

kindred tendon May 31, 2025, 5:42 PM

#

Nope, eject sucked it in when inverted. 1 did eject correctly.

south hemlock May 31, 2025, 5:44 PM

#

Can you run this? http://localhost:8000/docs/troubleshooting/troubleshooting.html#afc-debug-script

kindred tendon May 31, 2025, 5:45 PM

#

localhost?

south hemlock May 31, 2025, 5:47 PM

#

gah sorry

#

https://www.armoredturtle.xyz/docs/troubleshooting/troubleshooting.html#afc-debug-script

Troubleshooting - Armored Turtle Documentation

Armored Turtle Project Documentation

#

Sorry, was working on the documentation and had the wrong tab open 🙂

kindred tendon May 31, 2025, 5:47 PM

#

np

#

https://termbin.com/5aynk

south hemlock May 31, 2025, 8:54 PM

#

Sorry, had to goto the store and do some stuff for the wife

#

So, right now, lanes 1 and 2 are working correctly, 3 and 4 are not correct?

kindred tendon Jun 1, 2025, 12:53 PM

#

I cant repo now. I tried inverting pins but that was wrong. Have since reinstalled with the script. Maybe manual changes did it.

#BT_LANE_MOVE LANE=2 DISTANCE=-50 directions inverted on 3, 4