extruder screw | ArmoredTurtle 3D | Page 1

nova loom May 25, 2025, 6:45 PM

#

No matter what I do, the motor gets loose after about an hour of printing. Has anyone had this issue before? What should I do?

river wigeonBOT May 25, 2025, 6:45 PM

#

<@&1304550334839918672>

normal badge May 25, 2025, 6:57 PM

#

You mean the bolts back out of the headsets?

nova loom May 25, 2025, 6:59 PM

#

#

That one

normal badge May 25, 2025, 7:07 PM

#

What material did you use for the extruder? ABS/ASA?

nova loom May 25, 2025, 7:18 PM

#

pla

mental fulcrum May 25, 2025, 7:27 PM

#

oh, you should not do the motors plates in PLA. This can happen over time with heat from the motor #1274889345366626366 message

nova loom May 25, 2025, 7:29 PM

#

do i need to reprint all parts or only the one that holding the motor?

normal badge May 25, 2025, 7:31 PM

#

You can get away with only reprinting the motor plate 👍🏼

#

The gear of the motors is too much for pla

mental fulcrum May 25, 2025, 7:32 PM

#

So that was my build log, and I only reprinted the motor plates like weemantella said and have not had a problem since

#extruder screw