(SOLVED) g2e cutter issues | ArmoredTurtle 3D | Page 1

dull gale May 8, 2025, 7:25 PM

#

So I have lane 2 feding pooping pretty good ( its a start) but unloading is not going well. the filament cuts but its like it makes a heatcreep sstyle blob in the bowden and wont pulll back out. any tips? cutter is fully depressing.

willow leaf May 8, 2025, 7:55 PM

#

reduce your retract and pushback values

dull gale May 8, 2025, 8:01 PM

#

Ill give that a try tonight when i work on it agian. its also not a clean cut looks like shredded rope. when i tested the cutter outside of the printer it cut fine

errant idol May 25, 2025, 3:33 PM

#

@dull gale is this specific one good now? i think you alos have another help thread

dull gale May 25, 2025, 5:02 PM

#

Thought I closed this one lol it was good a while ago

#(SOLVED) g2e cutter issues