nightowl 5kg filament lane sensors not reliably working | ArmoredTurtle 3D | Page 1

hollow urchin May 4, 2025, 5:39 PM

#

hi guys, i have a nightowl running on an ercf board (canbus), and i just have one lane currently, it has 3 filament sensors, prep, load and hub, the hub is last and very close to the load sensor. I have an extruder motor between the prep and load, and its not reliably triggering the ingestion sequence. I see all the switches working properly inside klipper. I get this error when I try to load tool 5 and filament is triggered the prep sensor lane5 Current lane not loaded, LOAD TRIGGER NOT TRIGGERED ||==>--||----||-----|| TRG LOAD HUB TOOL Please load lane before continuing.

#

@tame ridge

tame ridge May 4, 2025, 5:50 PM

#

can you put a screen shot of what your filament sensors look like in your web gui for lane 5

hollow urchin May 4, 2025, 6:13 PM

#

it worked after i tried about 4 times.. inserting, it then grabbed it

#nightowl 5kg filament lane sensors not reliably working