glad knot
Hey, I've almost got my build wrapped up, but I've been having a heck of a time getting the wheel drives on. They're very tight.
I think I could hammer them on, but I'm not sure I'd ever be able to take them off.
Is it supposed to be this tight? Would it be a bad idea to sand the wheel drives down?
opaque ocean
you can ream them out with an 8mm reamer
they should not need to be hammered on
did you tune your filament for shrinkage?
glad knot
did you tune your filament for shrinkage?
I did with the cauliflower tuning cube, although it does seem like it would be the only thing that would cause this if it shouldn't be that tight.
you can ream them out with an 8mm reamer
I'll give this a go. Thanks!
opaque ocean
did this resolve it @glad knot ?
glad knot
Yes, sorry. It's been working well. Haven't had time to do the serial print yet, but have done a few multicolor prints. Drilling it out a bit worked well.