print-tuning
hotend values for an A4T & revo
Flushing Volume Documentation
purge tower and ending filament unload macro
[solved] High Flushing volumes but still getting color mixes
Layer shifts and strange extrusion patterns
[solved] Layer shift after color change
[solved] Scratchy print lines (PLA, 220c)
Clogging During Second Filament Change
issue with filament not reaching toolhead
filament grinding when loading
[Solved] Struggling with PETG through BT
[Solved] AFC Pausing at each filament change
Filament not making it all the way to the toolhead reliably
[Solved] First torture turtle print what I need to tune?
Bridging issues :'(
Servo Cutter arm cause printer to shutdown.
Poop too small
[solved] Not sure what else to calibrate
[solved] Flushing Volume Calibration Question
Clogging issue on lane change with ASA
[SOLVED] Blob on Purge tower
Clogging issues during lane change
Flushing Volumes test
Colour bleeding
layer shift
Randomly getting wrong colour layers
Bridging issue
Layer issue
[solved] Weird height issue after filament swap
Top Surface Issues
Not changing the Temperatur while Filament swap
No brush/wipe, and want to eliminate prime tower
Solved - Bit to much Oozing when wiping and kicking poop
Poor printing following bridges and gaps
[solved] Turtle neck slide cracking?
Printing the Lightbox logo cutout sucessfully?
Boxturtle parts
Getting so many clogs after the print ends
Excess blobs appearing in other colours
After changing small leaks
(Solved) Text issue in orca.
Hotend and retraction values
Stringing / Blobbing causing clogs on Unload. SB w/ TZ-V6 Hot End
Does anyone here use tip forming? If so, was are your tips. No pun intended
Hex fill no top/bottom walls print issue
Top layer artifacts on edges
Excessive oozing after T0/T1/etc. macro
Nozzle oozing when in park position during colour change?
Rapido 2 Plus UHF Tool stn etc
No retraction before tool change leads to slight stringing