build-help
BoxTurtle won't complete Self-test
Other
Turtleneck Blockages
Tuning
Initial Setup
Getting a klipper error and can't seem to figure it out
Initial Setup
[Solved] Cancelling poop & kick, want sufficient prime volume
Tuning
Hub Bowden length issue?
Initial Setup
Slack forming/Spool unwind-nightowl
Tuning
Other
Lane Stalling on unload
Tuning
Other
TTC MCU Disconnect
Other
[Solved] Lane 2 error
Other
using PLA as support interface for ABS prints.
Tuning
Other
TMC 'AFC_stepper lane2' reports error: GSTAT: 00000001 reset=1
Tuning
RatRig vCore 4 IDEX
Initial Setup
[solved] Initial startup errors
Initial Setup
[solved] Pulls filament out of extruder fully during filament change
Tuning
Lane unload problems on filament change
Other
Grinding filament and lane issue
Other
New to BoxTurtle
Build Issue
Initial Setup
[solved] Problem with light spools
Tuning
spool not winding fast enough
Tuning
[solved] First start up, getting: mcu 'Turtle_1': Unable to connect
Initial Setup
tn stays trailing/expanded. extruders in bt skipping
Tuning
[solved] Tool head filament switch not registering
Build Issue
[solved] Hub is not clear error
Tuning
Initial Setup
[solved] Loud noise when loading lane 4
Initial Setup
Is my Enraged Rabbit Burrow board cooked? Driver error.
Build Issue
Initial Setup
Unable to get AFC into DFU mode
Initial Setup
Variable unload speed
Tuning
Lettuce feeder fresh install\setup Diag script run. Mcu shutdon.
Initial Setup
(Solved) Error: /home/natas/printer_data/config/AFC/AFC.var.unit file not found.
Initial Setup
[solved] depressor to much long
Tuning
[solved] FWD & RWD Multipliers
Tuning
[solved] Movement after tool change
Other
Turtle_1 Timer too close?
Other
[solved] Not able to flash AFC Lite
Initial Setup
[resolved] Filament cutting knife
Build Issue
Other
[solved] Toolhead Endstop Sensor not reading correctly.
Tuning
[solved] FilamATrix CW2 Bowden length
Build Issue
Lane one ghost jam (solved)
Tuning
[solved] Extrusion issue
Tuning
[solved] spool falling off respooler
Other
[solved]Can't add debounce_delay to afc_extruder
Other
[solved] "The value 'lane0' is not valid for LANE"
Other
Clogging on Bambu Lab Hotend / CW2 / Stealthburner
Build Issue
Initial Setup
Other
[solved] BT wont unload. Giving up in betwe byen the toolhead and hub.
Build Issue
Initial Setup
[solved] Happy Turtle Lettuce feeder
Build Issue
All load triggers too tight
Build Issue
Internal error on command: "PREP"
Initial Setup
[solved] Hub Sensor not working
Initial Setup
Pi not booting when AFC Lite is connected
Initial Setup
Spoolers low torque
Other