#MLAT MLAT Map Marker disabled

1 messages · Page 1 of 1 (latest)

boreal hound
#

I have two feeders set up one using an old laptop and a new one using a Pi5 and adsb.im. This new one has a great antenna and receiver getting flights from over 200 miles away.
The https://globe.adsbexchange.com/?feed=AtH8JC4fm7_l feed pages shows all working well and at the correct location But the receivers page show the attached.
Also the stats page for this receiver shows fewer aircraft than my very basic old laptop station.
I am trying to work out what's going on here and why the receivers page shows everything hidden for this new feeder.
Appreciate any help.
Thanks

image.png
ADS-B Exchange - track aircraft live

ADS-B Exchange - track aircraft live - aircraft flight history

tall jasper
#

On the "Data Sharing" page you have the "Privacy" checkbox set.

vivid zephyr
#

Has it been up at least 24 hours? if not just give it a day to see if it resolves itself as the servers take a bit to sync up.

boreal hound
#

Thanks. I restarted the PI and it's all good now. However the Pi is creating quite a bit of RFI on my 20m band radio. It's located in the garden not far from my HF antenna. So, my next challenge is to deal with that!

boreal hound
#

Turns out that it's not the PI itself but only when powered. The official power supply and another that I have create no RFI when plugged in but as the PI boots the RFI starts. This does not happened when I run the PI using a powerbank. So - I need to look at some grounding.

tall jasper
#

This sounds very like ethernet noise to me from the frequency you say is affected. Try a shielded ethernet cable or 3 or so turns of the cable through a ferrite ring.

boreal hound
#

I am not running ethernet - only wifi.

boreal hound
#

Just an update. The folks from whom I bought the kit - RPI plus power supply kindly sent me a genuine RPI power supply and no more noise!