teal current
So I'm trying to make a crate for someone that holds vinyls but when i put the 3mf file into orca slicer i get an error and i try to repair it but nothing i get stuck at like maybe 15% and ive let it sit there for hours and not budge.. any ideas why? is it safe to just print as is?
sonic orbit
post the 3mf file
teal current
sonic orbit
why are you using a 0.2mm nozzel?
teal current
i havent messed with any settings i just loaded it and hit repair
sonic orbit
can you send the 3mf file from orca so i can see all your settings
teal current
are you mean layer heights? my nozzle is .4 i loaded it and saved it
it should load under coprint chromaset .4 nozzle ender 3 v3 plus
sonic orbit
it has non manifold areas , did you create it in sketch up?
teal current
no i got the file from I think printables than i had to edit some layers off the top and thats all i did
sonic orbit
that could have cause the issue
teal current
i was editing those off
sonic orbit
how did you remove them?
teal current
😂 i cant remember a different slicer iirc
sonic orbit
try removing them in orca slicer
teal current
how is that done 😂 im new to this stuff
sonic orbit
click on the part and then click on the cut model
