Orca Slicer is using wrong IP | OrcaSlicer | Page 1

shadow tapir Oct 13, 2024, 1:25 PM

#

Good morning all!
I tried to send a print job Ender 3 V3 Plus however, I couldn't becasue it appears that Orca slicer is using the wrong IP. Under the device tab I can see that the IP is different from the IP that I see on the printer. I do not see an option to change the IP address under the Device tab in Orca. Is there a different place that I need to configure the IP to match my printers IP?

pulsar lintel Oct 13, 2024, 1:28 PM

#

shadow tapir Oct 13, 2024, 1:32 PM

#

Thank you!

#

I am not sure why the IP address changed in Orca, is this a common issue?

pulsar lintel Oct 13, 2024, 1:58 PM

#

Never heared of this. The IP may dynamically change in your router but never in the slicer

#Orca Slicer is using wrong IP