After slicing, I noticed that there are areas in my prints where the volumetric speed is higher than where I set it. (Filament settings>Volumetric speed limitation>Max volumetric speed)
Help would be greatly appreciated 🙂
#Max volumetric speed broken?
nova nexus
dark flume
nope its working. It would help in general if you always post your project file and a screenshot of the problem
nova nexus
dark flume
Post your project file pls
nova nexus
working on it, sorry... I'm newer to OS and haven't saved projects before
dark flume
Just go file, save project or hit control s
dark flume
its the flow ratio
It appears taht the "flow cap" is calcuated before the flow ratio is applied - so in your case it bumps it up by 10%
nova nexus
aaah interesting
dark flume
Typically you dont have over 1 flow so it doesnt matter bt its a bug nonetheless, but a low priority one to address
dark flume
ah taht makes sense. Just reduce your flow cap by 10% and you're good
nova nexus
interestingly it seems like it's still just a touch above 10. probably not enough to make any difference though
dark flume
Nope wont make any difference at all...
nova nexus
obviously I just need to keep an eye on it, but it does make me wonder what else is affecting it.
9*1.07=9.63
dark flume
Slide the horizontal slider around and it will show you the flow rate for that line. The color coding isn’t helpful. Also you can press C on your keyboard to hide the gcode preview - in most cases it’s unnecessary
nova nexus
Thanks for the tips 🙂