[0.1.0-pre8-rc1] Cutter output tooltip goes under floating cutter image | Shapez 2 | Page 1

jolly sparrow Jun 7, 2025, 1:53 AM

#

I was looking at the nice new building information panel, and found that on hovering over the input/output that it pops up a tooltip with more information. On the information panel for the Cutter, the bottom output tooltip partly goes underneath the floating image of the cutter. See attached screenshot for what I saw.

#

[0.1.0-pre8-rc1] Cutter output tooltip goes under floating cutter image

spiral fern Jun 7, 2025, 11:08 AM

#

seems like the same as https://discord.com/channels/1000343719314198548/1378845445601886358

jolly sparrow Jun 7, 2025, 3:07 PM

#

Ah, I did try to check for existing tickets, but apparently not well enough.

#[0.1.0-pre8-rc1] Cutter output tooltip goes under floating cutter image