[SPZ2-3264] [0.1.0-PRE1-RC3] False positives on predictors

[lofty comet]

I have a simple setup to run one belt of source shapes to be processed on a platform. Cut and paste sets down a platform with four belts set up, but I didn't connect any extensions, as I don't need them. All is fine and well, but when I go to run the belt on the platform, I see four belts of the shape, whereas I would expect to see the shape only on the second input from the left.

[lofty comet]

[0.1.0-PRE1-RC3] False positives on predictors

[versed grove]

[SPZ2-3264] [0.1.0-PRE1-RC3] False positives on predictors

Thank you for your report! 🙂

I've added the issue into our internal system for further investigation

[lofty comet]

Woulkd you like me to make a quick repro map?

[versed grove]

If you think it'll add more I'd appreciate it. I was able to repro with with the first shape mine I found and a really basic setup

[lofty comet]

Yeah, that's pretty much what I would send, so you're good.

[opal elm]

Wait, I think this is related to what I was encountering, where copying and pasting something would show shapes that weren't even in that conveyer system.

I just didn't know what to call predictors, so they didn't come up in my search before creating my report.

[opal elm]

Assuming that this is the same issue I am encountering, which it sounds like it is, I encountered this issue in PRE2-RC2 as well.

[lofty comet]

It might be, there are a few bugs open on predictors, maybe wait until some get resolved and check again.