nocturne shale
The shape is a blue/red crystal circle topped by a yellow crystal circle topped by a plain circle. I can get the two halves of the bottom layer and I can drop half a circle on the red and blue circles and then I can add a half layer of yellow crystal, but when I go to swap shapes (which worked on another shape I made) and the swapper just destroys all of the crystal and leaves just plain shapes which do me no good.
Any suggestions?
marsh cedarBOT
dense haven
use a pin pusher on the circle, stack that on the blue/red then run that through a crystal generator with yellow paint input. crystal generators replace pins with crystals as if they were empty spaces
foggy sigil
If you want to use the swapper with crystal, make sure it's in the correct orientation. If a crystal goes through the line that's cut in half, it will be destroyed.
dense haven
you only need one swapper for this to make the bottom layer
nocturne shale
you only need one swapper for this to make the bottom layer
Bottom layer is fine, it''s the second layer I'm having an issue with.
nocturne shale
you only need one swapper for this to make the bottom layer
I'm working on this now. I have the cut lines all lined up and not crossing a crystal but it's still destroying all the crystals.
austere quiver
If a crystal is attached to another crystal, it's part of the same crystal regardless of color
nocturne shale
I finally figured it out. I had to create one side of the shape, crystalizing all 3 layers, and then I just ran the swap and it made the right shapes, circles.
obtuse arch